Snowmobile World banner

clutch removal. how to?

6K views 3 replies 3 participants last post by  zeek987 
#1 ·
i've never removed a clutch before on a sled, and i have a question or two...

using the specified clutch puller, is there springs or small parts i need to worry about falling off?

is there tension to be released after the belt is removed . mainly, do i need to be concerned about a spring shooting across the room?

i am planning to change the crank seals, its not leaking on the clutch side yet, but it is behind the magneto
 
#3 ·
so tell me if i have the procedure right then if you dont mind....

remove belt.
remove bolt on primary.
spray lube or grease in hole.
mark clutch for alignment.
thread in clutch removal bolt.
tighten, tap if needed. slide off the clutch.

does this sound right? am i missing anything?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top