I'm hoping that those of you who have already installed this kit on the ZX sc-10 2 and/or 3 can give me a few tech tips. I'm in the process of attching the rail extenion pieces to the actual skid/rail assb., but in the instructions the pics appear to be of the old sc-10 skid.

So only one of the holes actually line up, so my question is this: Do i line up the upper hole on the factory rail(uper hole where track tensioner bolted on) and just drill out the rest? I know some of you guys have done this and it was mentioned that a few minor mods were needed to make the rail extension fit properly, so any tips would be greatly appreciated :D My wife would be greatful to get the skid off of the coffee table as well :p

My wife would be greatful to get the skid off of the coffee table as well

Now THAT'S funny!

I sent you a couple of PMs. Lemme know if there is anything else I can help you with about adding the extensions.

I got the PM, thanks :D It's closer to the beer fridge working inside :p I'm going o notch the extension rails slightly as you suggested for a better fit.

Holy crap your not done that yet??? man where are your priorities?
how did the test go ???