I have purchased a reverse kit for my 99 powder special 600 efi. does anyone have a pic they can post to help me figure where I need to cut the hole for the lever?

Arctic Cat doesn't have a template for this do they?

Thanks! SWRules

I'm pretty sure if you look on the rear of the plastic panel theres a marking where the hole needs to be drilled. If not I would assume yours is the same as my 02 and has the aluminum support already drilled, if so just drill in the center.

Rick.
:christmas:

Like Rick said, I put one in my 99 ZR and there is a round imprint on the backside of the plastic, thats where it goes. Look at most any newer Cat an it will give you a idea.
Todd

Me too...my 99 800 Zirt had a template hole in the backside of the plastic...

:withstupid: Theres a hole outline there that will show you where to drill. Reverse may add a few pounds but makes it alot easier when unloading off a trailer.

Thanks everyone! Got the job done.. I still need to adjust the linkage but it's all in and much more straightforward than I thought!

:blush:

Make sure the linkage is adjusted to spec, the tool / fixture required is very cheap from AC.

Rick.