I have a 1995 Xlt special 600 w/ PSI pipes. They say I need 10mm red weights, blue primary, blue secondary, 34 degree helix, 40 pilot, Q0 nozzle, stock needle, 240 pto side and 230 center mag side. Does anyone know what is stock on the xlt special and what I actually have to change? I am not very mechanically inclined and would like to buy the stuff I need prior to tearring it apart. Thanks!!!

You should only have to change your jets, needle seat, and clutch weights. Since you have PSI pipes I would double check with what you need to put in for elevation. It will most likely be a little different then the book calls out for a stock sled without aftermarket pipes.