Just got my 01ZR5 back from a drive shaft bearing replacement. 100 miles later I now have an extremely bent rear shock shaft and parallel bars. I had the shocks all rebuilt earlier without trouble. I rode about 75miles on the bad bearing before replacing it and my track was out of alignment. Is it possible I stressed the rear shock at that time?

Also, I posted last week a strange vibration through my feet after the bearings were replaced but couldn't figure where it was coming from.

I just cannot imagine how I bent the shock. Do these things stick? Everything looked like it was properly reinstalled (ie skid frame). Any thoughts?

frozen shock. water inside froze up and then it wouldnt compress. when was the last time they were rebuilt??