mtrsprt
03-17-2004, 02:41 PM
Pulling the carbs this weekend to clean and re-jet for the mods that I am doing to the Z.
Cudney is porting it, supplying new piston kit,VF2 reeds,and including gaskets.
Going to be running Dynoport triples w/can.
He suggested to start the mains at 400. So, I purchased three sets of mains.(360's.380's,and 400's)
This sound like a sgood place to start?
Engine will be in the 185-190hp range and have about 150psi compression.
I ride at about 400-900ft ASL, and temps are usually no lower than 0*F.
Cudney is porting it, supplying new piston kit,VF2 reeds,and including gaskets.
Going to be running Dynoport triples w/can.
He suggested to start the mains at 400. So, I purchased three sets of mains.(360's.380's,and 400's)
This sound like a sgood place to start?
Engine will be in the 185-190hp range and have about 150psi compression.
I ride at about 400-900ft ASL, and temps are usually no lower than 0*F.