I've got an Enticer 300 with a clutch that's making some noise. I'd like to take it apart and inspect/rebuild but I cannot figure out how to hold the clutch to take the bolt out and then get a puller on it. My arctic cats have 9 tower clutches and I can put a crow bar through the towers to hold the clutch while I remove the bolt and use the puller. How do I hold this yamaha clutch? There are no holes for me to insert anything. Do I need to get a special tool or can I rig something up, I hope?

Thanks!

You can make a tool similar to an oil filter remover (the strap type). Just go to a parts store and see how they're built and make one on a little bigger scale. Ken.