Anyone know if a 1.25" track will fit under a C-7 F-chassis sled?

I would say no, not enough clearance. I had a 95 FZ with a 1" aftermarket track on it. (bought it like that) It seemed to take a s@#t kicking. Maybe the drive sprockets could be reduced. What did the Summits have? Maybe Perm or some of the other Doo'ers could give you some better advice.

I can't say for sure but i'd bet against it.you'll probably have to get smaller drivers to run it.

Good luck,
Dan

There is enough room.

Hahaha...thanks Mikadoo...and to think I thought I had a straight simple answer haha

Has anyone actually done it?

I had a 94 FZ. It came with an 880 lug track. I put on studs that were 3/8" past the lug which would =1.25 and never had a problem tearing up the bulk head but I would'nt try studding the 1.25.
After all, this is an f-chassi same 9 tooth drivers that all engine sizes came in no matter if it had a C-7 or SC-10. Trust me, it WILL work :thumbsup:

alrighty then..thanks :lol:

I've run my 1996 F-III (F-body, C-7) with a Camoplast 1 1/4" many years with no problem.

Pierre