So are you using 2 probes on your single pipe mxz800 or only one?What do you recomend?Can you email me any more info on the fixes 4 mid range leane spot with rkt head?tcsonier@nb.sympatico.ca

When I finnish testing in the fall I hope to have something available. *I did not want to post bad info on the head, in fact it is very good. *Just some issues that I felt needed addressed. *Kelsey is working as hard at it as I am and between the 2 of us the issue should be fixed. *

GLH

And as for the probes, should I put two or is it as good and acurate just one?Thanks

I prefer the 2 probe method, quite often one cylinder will run hotter than the other, this allows you to stagger jet if you need to.

GLH

How many inches from the cyl. do you put them?

the race manual shows 100mm from the face of piston. probes look to end up just before the "Y".