|
|
||
|
Vulcan 1500 12-11-2004, 07:21 PM I installed a factory temperature gauge on my MXZ700 which appears to work fine, except the warning light in the guage stays on. I put in the correct sending unit, (new), tried switching the wires around, but nothing changes. Does anyone have any ideas?? Welby24 12-16-2004, 07:30 PM You have to disconnect the idiot light,before it will work properly......... Welby24 12-16-2004, 07:38 PM - CAUTION Disconnect temperature indicator warning lamp wire. If this in not done, none of the indicator lamp or temperature gauge will function properly. As stated in Doo manual........hope this helps...... Welby24 12-17-2004, 06:57 AM Did that work Vulcan? gravy davey 12-17-2004, 09:16 AM I installed one on my wifes MXZ500 as Welby24 said you have to disconnect the idiot lite. Vulcan 1500 12-18-2004, 07:51 AM Many thanks to all who replied about the gauge. I disconnected the idiot light as the instructions stated, but the light stays on anyway. The gauge is used; the sending unit is new. Is there a way to check the gauge? Once again thanx to all. | ||