just put motor together for my 1993 xlt 580, i have 200 mains, it runs but i think that i need to sync the carbs! *but i've never done it before, so please help!!!!

what is the distance between the carbs & the barrels??
what should the idle screw be at??
brass air screw at??
high idle rpm? *low idle rpm?
ingagement of the clutch??

First of all you need a carb sync tool. *do you have one! *If not get one.

I THINK THAT I'VE GOT A TOOL THAT GOES IN THE FRONT OF THE CARB. *IT'S GOT A LITTLE GAUGE WITH A BALL IN IT, BUT I'M NOT SURE HOW TO USE IT?

I WAS WONDERING WHERE I COULD GET SOME CARB SPEC'S TO HELP ME OUT???

THANKS AGAIN!!