I have a 2003 F7 EFI sno pro and i can't seem to get the flywheel off, I am using a harmonic balancer puller, which should work, but the flywheel wont budge. Do you have any suggestions?
Thanks!
Nate

use a 3 ' Johnson bar and give it a good reef, should pop off, they are tight though. I use my clutch tool to hold the crank from turning.

Give the center post a good strike with a hammer and keep tightening the puller each time you do it.

Heat the crank with a heat gun while the puller is applying a good amount of tension then grab a catchers mit

Heat the crank with a heat gun while the puller is applying a good amount of tension then grab a catchers mit
[/b]


:lmao:

Been there!

I have tried everything, but the heat. I was a little leary of heating it up because of the stator and other electronics, or is this not a concern? Thanks for all the input!

Nate

Preferably use a heat gun and be concious about it....

You just want to expand is a little bit....