Well I finally decided to do it after much pressure from good ole' Sledheaddude800.
I bought the pivot riser extension and a 4" block to put on my '01 ZR 800. I ordered the brake line extesion from High Performance Engineering, it came with the line and two fittings. Both of the fittings were the same so I know i'm not putting them in the wrong place. I was able to get everthing to fit on the brake caliper with no problems. When I went to screw put the fitting on the master cylinder I noticed that the threads looked too coarse. I just barley starts to thread but it's really tight, and I don't want to end up ruining my master cylinder. The pictures show what they sent me. Did any of you get the same set up or is it wrong. I called the support people at hiperf and they told me that this was a standard size for all cats with willwood brakes. I showed my dealer and the only advice he gave me was to tap it to the correct size. I don't think I should have to do that?

The right side of the fitting attaches to the brake line itself, the left is supposed to go into the master cylinder.
HELP! :bash:

lose that pos go to slp and get a whole new line

definitely two different threads

* looking on SLP's site...credit card out*

Heres what you should have gotton! this is what I have on the 2001 MXZ 800

Spend a little more and you'll have no issues! :thumbsup:



CLICK HERE! (http://www.startinglineproducts.com/catalog.cfm?pageID=detail&catalogID=2&catID=10&productID=40) :)

* looking on SLP's site...credit card out* [/b]



THANKYOU !



Heres what you should have gotton! this is what I have on the 2001 MXZ 800

Spend a little more and you'll have no issues! :thumbsup:



CLICK HERE! (http://www.startinglineproducts.com/catalog.cfm?pageID=detail&catalogID=2&catID=10&productID=40) :)

[/b]





what type of brake fluid should he use Dave ?

THANKYOU !









what type of brake fluid should he use Dave ?

[/b]



Bel Ray DOT 5