Guys, I'm re-doing an old skidoo citation, and I noticed the jackshaft is worn where it sits in the bearing which lies in the clamp. If you're not familiar with it, it's the shaft that the secondary clutch is mounted on. There's a fair bit of wobble there and it's not the bearing. I'm using this sled for ice fishing, and so far , the wobble doesn't interfer with belt travel, and it's not wearing bad. Will this hold up, for what I use it for?

Guys, I'm re-doing an old skidoo citation, and I noticed the jackshaft is worn where it sits in the bearing which lies in the clamp. If you're not familiar with it, it's the shaft that the secondary clutch is mounted on. There's a fair bit of wobble there and it's not the bearing. I'm using this sled for ice fishing, and so far , the wobble doesn't interfer with belt travel, and it's not wearing bad. Will this hold up, for what I use it for?[/b]


to be honest with you. I wouldnt ride it any further than I was willing to walk back .jmho M