hi guys im having probleme with my clutch set up im running 295 x ramp in front and in the secondary ive playing with the set up abc 12346 set up i cant find the right set up i cant pull my rpm the best i managed was 7800 rpm tryes everything and still cant get it right im in need of help anyone please

What helix are you running in your secondary? Studs? Rider weight? Any mods done? RER?

You shouldn't try to regulate your top speed rpms with your secondary. Use the clickers or flyweight in the primary to bring the rpm up.

We need to know which spring and pin weight in the primary. I like 180/200 for the engagement and 350 for the big end running 19 gram pins. secondary 50/47 doo beige (b-5 ?) spring 20 lbs break away.

What helix are you running in your secondary? Studs? Rider weight? Any mods done? RER?

You shouldn't try to regulate your top speed rpms with your secondary. Use the clickers or flyweight in the primary to bring the rpm up.[/b]
im running a 50/47 helix with a 1.25 ripsaw track and i weight 235 pounds with carbon reeds thats a bout it for mods im wondering if the ramp a stock i know that stock they call for 295 ramp but mine are 295x for the spring it a beige one in the secondary and for the weight in front i dont know will take a part to check i dont know if the info i gave you is good i try again last night and i pulles 7500 rpm it pulls hard at the start and dies around 70 mph and stays there for the longest times and slowly creep up to about 90mph my engine is brand new the crank rod piston everything i will take any info and thanks in advance for time guys well apreciated

I would check that the carb slides are opening up all the way-throttle cable adjustment.
choke cable adjustment and that the oil pump is set on the marks. If all those items are correct the clutches need to to be checked for binding. Are either of the clutches hot after you do the test run?

hi guy i just finish rebuilding my engine and now im in the testing process right now my clutch engage at 5400 rpm quite a snap a little too much for me a have 295 x ramp right now i was wondering if anybody has the recipe for this sled or a site with all the recipe for drag trail lake runner and all it will save me a lot of money and time thanks in advance[/b]

Is this your engagement still? It sounds a little bit on the high side. Which primary spring are you using?

Also, check to see if the rave valves are moving freely. I worked on a friend's 99 Mach 1 that was only running about 7700 rpm. I had just cleaned them in the spring, so I checked clutches, carbs, compression first, not even thinking of the raves because I cleaned them for him in the spring.

I cleaned them up, and instantly the rpms went to right where they should be.