Hello,
I'm going to be going over the the Whitestar auction next weekend. I'm hoping to buy a sled and a enclosed trailer. I will be going back over the next weekend to pick the trailer up. Is there a way to tell what size ball I would need for the trailer? Would I just need to measure inside the coupler? I don't want to show up to get the trailer with the wrong ball size. :confused: Any advice would be great.

Thanks

on top of the coupler ,stamped right in it you will be able to read what size ball it takes

it will either be a 1 and 7/8" or a 2" why not just buy both? they are cheap enough. Unless you are buying a BIG 4 bed enclosed... then it will probably be bigger :p

Ive never seen one that wasn't stamped on it somewhere.
Or to be SAFE just get an 1 and 7/8 and both sizes will fit on it. :rolleyes:

Not really but it sounded good.

go to you local ct and get the ball that has the multiple sized sleeves for it ranging from 1 7/8 to 2 1/4.

Or just pulla sled ed move and jam it into the bumper till it hooks up and good to go


go get a sled already so we can ride!

I'd bet on the 2" - unless somebody has replaced the whole coupler assembly for whatever reason. In any case, if the coupler fits down over the 2" and locks, it's not a 1 7/8" coupler. It COULD be a 2 5/16", but those are pretty big couplers, usually only found on trailers rated 3000 -3500 pounds and up. I suppose you could have one of those with you, try it to see if it fits up in the coupler, and return it if not?

I've got a 2 up enclosed Continental Snow King trailer and it takes a 2-5/16" ball.

2" for the 2 place sled trailer.... 2 and 5/16 for the 6000 lb. boat trailer