There was a post a while back concerning the use of the sled pro tool on the zx chassis. *It was brought up that a spacer is needed to properly use the tool with RER. *Have emailed sled pro to send me the spacer, and they replied that they would. *In the mean time, I was wondering if someone had the measurement for that thickness, and is that from the tool to the spacers Doo has on the shaft to begin with. *Looked at my belt last night, *Center to center is fine with tool but offset is unknown, and pulled a serious piece of cord of the side of the belt. *Thanks in advance.

There is a cup washer on the 02 800s behind the RER secondary. *I found that you can use the sled-pro tool with that washer behind it and get the exact spacing needed. *I verified this with the old "straight bar" method.