Hi again!

I own a 04 sabercat 7.

I was going to order a riser block from rec supply and It had said most sleds will take a 2 inch without any cable mods. (Was looking at a 5" riser block)

I priced out throttle extensions and brake cables.

That is the easy part. As for the electrical wiring? is it a pain in the you know what?

Please give me advice, thanks again!

you wont need anything for a 5" riser... I have a 7 on mine and didnt have to do anything. but if its electrical you're worried about, dont be, theres miles of it under there

They say you can only get a 2 inch without getting brake and throttle extensions, I also checked under the motor and I couldn't get more than two inches of slack, so I don't see how you could put a 7inch on and not get modifications.

I have a 10 on mine, no extensions.. Just clipped a couple of zip tyes and rerouted some cables..

Mine is a sabercat though, so the handlebars are a lot lower stock than the f7.

Maybe on the f7's they have more cable length?

I'm going to stab and say they use the same harness, but I'm really not sure..