I would like to see if you guys know a better ice set-up.
The sled runs great but I know it has more potental.
I just don't have the knowledge.
I ran this set-up on asphalt an ran a 10.90 @ 8500 R.P.M.'s
Just curius what you think.
800cc .059 base gasket
head cut .063 squish
39.5mm board carbs, 380 Mains
v-force II Reeds
Air box gutted
stock pipes
dyno-port can
24-43 gear ratio
230-320 primary spring, 295 Ramps, 19.5 gram pins, clicked @ 2
Stock sec spring with 42 black ice helix, 20 lbs
If you can pull it, I would increase the size of the secondary helix a bit. On the ice I like to run like a 54/46, but I never had any luck running those 295's. I like 145 ramps if traction is no problem on the bottom. Everyone's different with their tuning idea's and there is a lot of ways to get to the same point.
to me your gearing seems a little low. i find that even if i run .590 it pulls hard but not enough legs at the end of 660.. and your running .558 so even at say .590 or what i run is the stock at .604.. you say that traction is not an problem then i would suggest running a 286 with the 230\380 or you could go with the 230\410 and add more pin. your cam sounds a little shallow to me with the right amount of lbs. i would more along the line of a 46 black ice or what ever works out to 50* but the 46 b/i would be best
