I just added a set of VForce3's as well as reed spacers and now it idles okay for about 10 seconds or so, then acts like it is loading up. It does clear itself right out as soon as I go again. It also seems to start harder than it did before the parts were added. I am looking for suggestion to correct this. Drop the needles?? Change low speed jet?? Thanks.
Was there no information with the new parts? Usually if a jetting change is required they would inform you in the package. Perhaps a call to the manufacture?
Have you double checked to see if everything is back together properly and tight?
Good Luck
__________________
2010 GSX
Wife 08 Vector
Son 2012 Nytro XTX
I have looked everything over and it is all installed corectly. In the VForce3 package it did say that jetting may be required, but that's all it said, there were no specifics. It did say to start with whatever you had in it before and adjust from there. I assume they mean that you may need to go up a size on the main in some cases. The idleing issues is not realted to the main's (I don't think) in any way.
