I have a 97 XCR 600 with 3400 miles on it. I did a compression test on it and it read about 105 psi across all three cylinders. This seems low, but I don't know what it should be. If and when I tear it down where can I get the specs to rebuild it ? I've tried to locate a shop manual but haven't had any luck.
Should I have the bottom end torn down and checked out or just replace the pistons and rings. Or is it to early to tell until I get it torn down?
Any help would be appreciated.
__________________
2005 Mach Z
2004 GSX Limited 600 H.O. S.D.I.
