Driven Clutch Stuck! - Snowmobile World : Your #1 Snowmobile Forum
http://www.snowmobileworld.com/forums
» Sponsors
Go Back   Snowmobile World : Your #1 Snowmobile Forum > SNOWMOBILING SECTION > ARCTIC CAT

Reply
 
Thread Tools
Old 10-22-2005, 02:59 PM   #1
Z-Rider
Senior Member
 
Z-Rider's Avatar
 
Join Date: Jan 2003
Location: Davison, MI
Mileage: 765 miles
Primary Sled: 2002 ZR 800
Where I sled: Northern MI and the U.P. of MI
Posts: 610
Thumbs up

I was replacing the clutch springs on my 2002 ZR800 this morning and ran into some trouble. I just bought this sled a few months ago and am not sure if the clutches have ever been removed. I was attepting to remove the driven and it was a hard to move on the jackshaft. I pulled the keyway with a magnet and started to rock the clutch back and forth with the parking brake set. It would move a little in each direction and so I started to pull it from the shaft as I continued to rock it. It tighted up after moving about 1/8" so I pushed it back on to try again now it will not move. I cannot get it to even rock let alone slide on the shaft. Any ideas as to how I should tackle this. I sprayed it with penetrating oil and warmed it slightly with a propane torch and it still will not move. Is there a safe way to pull a driven or should I just heat it up some more. I do not want to have to take it to the dealer because I am on a tight budget right now.

Any help, I would be greatful,

Homer
Z-Rider is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old 10-23-2005, 11:10 AM   #2
live2hunt
Junior Member
 
Join Date: Jul 2004
Location: Grand Forks, ND
Primary Sled: 2002 Mounain Cat 800efi
Where I sled: anywhere there is snow
Posts: 8
Default

You can tip the sled on its side and spray some penetrating oil on it and allow it to sit overnight in order to let the oil work its way between the shaft and the clutch. Then you can heat it up a little and try it again.

That being said, I had a stuck secondary on my Cat and couldn't get it off for the life of me. Finally I broke down and got the secondary puller that Cat recommends and it came off with ease. If you can't borrow the tool from your dealer, you should consider buying one. They are worth their weight in gold!!! You don't have to worry about damaging the clutch let alone all of the frustration.

Make sure to put some anti-sieze on the shaft before you put the secondary on again.

Good luck!
live2hunt is offline   Reply With Quote
Old 10-23-2005, 04:22 PM   #3
Z-Rider
Senior Member
 
Z-Rider's Avatar
 
Join Date: Jan 2003
Location: Davison, MI
Mileage: 765 miles
Primary Sled: 2002 ZR 800
Where I sled: Northern MI and the U.P. of MI
Posts: 610
Default

Update:

Well I got it off today. I had my uncle come over to help load it as I could not drive it onto the trailer. He was looking at it and came up with this idea. I was able to remove the keyway last night when I was working on it so what we did was put the bolt back in and install an old belt. I then started the motor and while holding the brake I "bumped" the throttle just enough to engage the primary for a split second. I did this like 3 times and it came loose. Not sure if this was the best or safest way but she came loose with no damage. It appeares that the prvious owner had never had the secondary clutch off the sled as recommended for greasing. She is all back together now and all appears to be fine.

Z-Rider
Z-Rider is offline   Reply With Quote
Old 10-24-2005, 08:42 AM   #4
ZR Rider
Senior Member
 
ZR Rider's Avatar
 
Join Date: Nov 2002
Location: Greg in Bowmanville, Ontario
Mileage: 130miles
Primary Sled: 97 ZR580 EFI
Where I sled: Central, Eastern and Southern Ontario
Posts: 1,229
Send a message via MSN to ZR Rider Send a message via Yahoo to ZR Rider
Default

So now you know how important it is to pull that secondary every spring, wipe it down, light sand and regrease. Welcome to the club! Been there! lol

Another way, one of those ball joint tuning forks. Down between the frame/bearing housing and the clutch and give it a few whacks!
__________________

<span style="color:green">Cat&#39;s Pride Member "94 - 06"
1997 ZR580 EFI</span>

Arctic Cat</span> "What Snowmobiling&#39;s All About"

Kanalco Limited - Aluminum Panel Systems
Arctic Cat
<span style="color:green">GMC Trucks

Bosch Power Tools
Dremel Tools
RotoZip
ZR Rider is offline   Reply With Quote
Old 10-24-2005, 03:46 PM   #5
Z-Rider
Senior Member
 
Z-Rider's Avatar
 
Join Date: Jan 2003
Location: Davison, MI
Mileage: 765 miles
Primary Sled: 2002 ZR 800
Where I sled: Northern MI and the U.P. of MI
Posts: 610
Default

ZR Rider,

Yea I know they need to be pulled once a year for clean and grease. I just bought the sled in August and have finally finished going through everything. Should be ready for snow now.

Z-Rider
Z-Rider is offline   Reply With Quote
Old 10-24-2005, 04:43 PM   #6
dajetfixx
Senior Member
 
dajetfixx's Avatar
 
Join Date: Aug 2002
Location: Wisconsin
Mileage: 100
Primary Sled: 2003 F-5
Where I sled: Northern Minnesota / Northern Wisconsin
Posts: 374
Default

As I was reading this I thought the same thing you did....
dajetfixx is offline   Reply With Quote
Old 10-25-2005, 10:40 PM   #7
puree
Senior Member
 
puree's Avatar
 
Join Date: Feb 2003
Location: Northwest Ohio
Mileage: 2550
Primary Sled: 2009 Renegade 1200
Where I sled: Newberry, Grayling, Home, anywhere there is snow
Posts: 10,054
Send a message via Yahoo to puree
Default

had the same problem the first time I pulled the driven off my old zrt,,,, I grease them every year now,,, dont ever want to go through that again.
__________________
09 1200 Renegade
10 1200X Renegade
03 F7
07 F6lxr
03 Z370es
78 Invader 440


puree is offline   Reply With Quote
Old 10-26-2005, 12:29 AM   #8
FreezerBurnt
Senior Member
 
FreezerBurnt's Avatar
 
Join Date: Mar 2001
Location: Sudbury,Northern Ont
Mileage: 1268
Primary Sled: 01 ZR 600 VEV
Where I sled: Chelmsford,Northern Ont
Posts: 4,869
Default

I gave a quick hit with a rubber mallet
__________________
Current sled 01 ZR 700 X
3.5 Oles Machine riser,1.25 ripsaw,388/389 rear springs,45deg hooks,Shell Utra Oil

Previous sleds
-69 Dauphin--71 SW 396--75 GPX338--85 Safari 447--87 Safari 377
89 Safari Scout E--84 SRV 540--86 SRV 540--91 Indy 500--87 Indy 400
2nd 91 Indy 500
--95 STX 583-- 01 ZR 600 VEV
Current weather in Chelmsford
FreezerBurnt is offline   Reply With Quote
Sponsored Links
Advertisement
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Powered by vBadvanced CMPS v3.2.2

All times are GMT -5. The time now is 04:12 AM.



Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.