Yamaha Phazer 1995 that needs engine work. I blew the clutch side piston in it. Currently it is torn down and I have a new wiseco piston for it and the cylinder has been bored for it as well. I also have all the gaskets to put it back together, just need the wrist pin and bearing. I bought the sled and fixed it up, bored .20 over and promply blew it up. I then took it back to stock (had pipe, reeds ect all that stuff is gone) and blew it up again same cylinder. I'm done with with wrenching on sleds, buy one complete. The sled has new shim kit in the front, new studs, newer track, new oil pump, new cables, new fuel pump, everything was went through including the suspension (new springs, bearings for idler wheels ect). I took the clutch apart too clean it up and broke it (see pics), seat has a tear in it, the side panels fasten together but are broke where they latch although they don't flop down when riding it. It would be a great snowmobile for someone with the knowledge or to use it for parts. I have approx 1400 into it.
I would like 500 for it.