Where I sled: St. Germain Vilas County Wisconsin WI
Need more help! RAVE valve removal 1995 mach 1
Sorry guys I am in need of a little more help. Can someone please tell me how to take off the rave valves on a 1995 Mach 1? The setup isn't like I've seen on other sleds. Many sleds have them on the outside of the valve actually bolted to the outside of the motor block others are inside the rave valve cap but the nuts/bolts/allen screw...ect aren't covered up by the plastic piece inside the front cover of the valve. How do I remove this plastic piece to get to the bolts behind it after getting the first initial outside plastic cover off? Thanks!
If you do remove the guitine or rave slide be careful to re install the correct way or piston could hit. When I take them apart I unscrew center out, carefully pull rear rubber over center leaving tie wrap on. Then you can unbolt. When you re assemble if your careful you dont need to replace tie wrap.