Snowmobile World : Your #1 Snowmobile Forum - Reply to Topic
Thread: 1986 Enticer - Running Rough - Help Please Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Snowmobile World : Your #1 Snowmobile Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
01-04-2016 10:07 AM
BCDan Plugs look good, maybe a tiny bit lean, the jetting would be marginal if the weather turned colder. You have tried all the stuff I would have tried, except for unscrewing the plug cap and snipping 1/4" of wire off the wire, then screwing the cap back in. Sometimes the connection at the wire to the plug gets bad, and fresh wire may help.

If the compression gauge is accurate, 100 is marginal for a good running engine. It may be time for some new rings/pistons. But I would be going like you have; searching for an electrical issue that is worse when the engine is warm.

Good luck.. hunting down these kind of gremlins can be an exercise in frustration!!
01-04-2016 05:55 AM
happyhab
1986 Enticer - Running Rough - Help Please

I bought this old 340 for my son and he's just begun his 3rd season with it. I took a buddy's advice when looking for an old sled to find a nice clean Yamaha 340. It's been great and has provided hours of enjoyment. Up until now the only issue we ever had with it was the coil wire detaching from the coil body. I was able to carve back the plastic/rubber far enough to solder it back on, taped it up for safety, and never looked back.

This season it fired right up and was working great until just recently. It still starts up fine and after it's warmed up for a minute or so, we can do a few rips with it but then it loses power, sputters, coughs, pops, misses, and just won't rev up any more. You have to kinda feather it back to the garage.

- Fresh fuel
- Fuel pump working
- no change with choke on
- I've swapped plugs, no change
- I've swapped coils, no change
- I've cleaned the carb (it was fine), no change
- compression when warm 100/105 psi
- sprayed brake cleaner on PTO side of crank and intake gaskets, no change

I've attached a picture of the plugs and they are light brownish, but maybe just a touch lean? Also the oil pump setting is threaded outwards from the carb bracket to the max (for max oiling). And, we also put a blurp of oil into the gas tank for safety.

I have another '81 Enticer here and thought I could swap CDI's, but the wiring connections are not compatible.

Am I missing anything else????

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome