Snowmobile World banner

1 - 5 of 5 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I have to put new pistons into my sled so I thought I may as well put a new water pump belt on as well while everything is torn apart. Upon initial inspection, I don't know where it is located or how to get at it?
 

·
Registered
Joined
·
2,560 Posts
Just pull the mag cover. You can leave the oil pump in place as long as you're paying attention when reassembling. There's a key/slot setup between the drive and the pump. Just make sure they're lined up prior to tightening the bolts. You'll see what I'm talking about when you pull it down.
 

·
Registered
Joined
·
530 Posts
Just pull the mag cover. You can leave the oil pump in place as long as you're paying attention when reassembling. There's a key/slot setup between the drive and the pump. Just make sure they're lined up prior to tightening the bolts. You'll see what I'm talking about when you pull it down.[/b]
If you need a belt, I have an extra one still in the package.
 

·
Registered
Joined
·
2,782 Posts
According to Polaris' maintenance, that belt is supposed to be replaced yearly too.
 
1 - 5 of 5 Posts
Top