Snowmobile World banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
ok we changed the pto and magneto seals and it runs again. But not we are havin a very dificult time getting it to start and once its running u have to throttle up constantly or she just stalls out. We tried adjusting the carb with no luck. I personally think its a timing issue, we are un aware of where the internal coil was supposed to be set to adjust the timing so we just centered it up. My friend is thinking its a carb issue and is takin the carb of his to see if that soves issues. Does any of this sound familiar to anyone? Before it blew the seals it was running fantastic on the carb on it now. Opinions???? Similarities???
 

·
Registered
Joined
·
47 Posts
I pulled the carb and boot off mine, it really didnt solve anything. On the timing its got 4 marks, on each end its got bigger lines. I have it set dead center between the two big marks. WE've checked ALL Ign. parts good good and good. I couldnt seem to fine Compression specs to see if it needs a set of rings..
 
1 - 2 of 2 Posts
Top