Snowmobile World banner

1 - 3 of 3 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
just put motor together for my 1993 xlt 580, i have 200 mains, it runs but i think that i need to sync the carbs!  but i've never done it before, so please help!!!!

what is the distance between the carbs & the barrels??
what should the idle screw be at??
brass air screw at??
high idle rpm?  low idle rpm?
ingagement of the clutch??
 

·
Registered
Joined
·
791 Posts
First of all you need a carb sync tool.  do you have one!  If not get one.
 

·
Registered
Joined
·
40 Posts
Discussion Starter #3
I THINK THAT I'VE GOT A TOOL THAT GOES IN THE FRONT OF THE CARB.  IT'S GOT A LITTLE GAUGE WITH A BALL IN IT, BUT I'M NOT SURE HOW TO USE IT?

I WAS WONDERING WHERE I COULD GET SOME CARB SPEC'S TO HELP ME OUT???

THANKS AGAIN!!
 
1 - 3 of 3 Posts
Top