Snowmobile World banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Can someone share some info? Picked up this cheap sled for fishing that sat for 6 years. I did the carbs and it runs pretty good however I noticed when I switch the hand warmers on it does not want to rev. out and sounds like it's misfiring. Also when it warms up it does the samething without the warmers on but not al the time. Any ideas?
 

·
Registered
Joined
·
686 Posts
That is strange because the lighting circuit is different from the ignition circuit. They have different coils in the stator. It may be the stator going bad or a bad ground connection somewhere.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks for the reply. I think I've figured it out. Connectors on the wires coming out of the motor could have been a little loose. Check each one and seems to be alright when I ran it in the backyard. Tomorrow I'll take it for a good run. Fingers crossed.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top