Snowmobile World banner

1 - 6 of 6 Posts

·
Registered
Joined
·
242 Posts
Discussion Starter #1
I was wondering what thickness base gasket these have stock, and what the stock squish is on these, I just bought the sled and am trying to figure out if anything has been done to it,
 

·
Registered
Joined
·
242 Posts
Discussion Starter #3
I found that the base gasket is .065" thick, which sounds pretty thick to me the main jets are 420-410-420, is it normal to have a smaller jet on the middle jug? and the squish is .065" not sure but doesn't seem very "stock" to me:) :devil:
 

·
Registered
Joined
·
2,885 Posts
I would definately say that someonw has shimmed the jugs on ya.

It is normal to have the center jug one jet richer cause it holds in more heat than the outer cylinders.
 

·
Registered
Joined
·
242 Posts
Discussion Starter #5
the center jug on mine is one size leaner than the outside cylinders, it is 410 the outside two are 420
 

·
Registered
Joined
·
2,885 Posts
Sorry, my logic was there, just couldn't get it strait. It should be one leaner in the middle.

The tripple sleds with the single pipes (FIII 700, and 800) were one jet richer in the middle because the center cyl flows differently than the outer.
 
1 - 6 of 6 Posts
Top