Snowmobile World banner

1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1 (Edited)
So I took the sled out of the shop so the kids and me could go for a ride we got 10 inches here last nite started it up was running and sounded ok turned around to close the shop doors and it stopped like someone hit it with a hammer!!!! went over to it and tryed to start it again but the recoil had a ready hard spot to pull than it would go over. it has lots of spark, so I took it back into the shop and took the recoil off and I couldn't turn it by hand. I used a bar to turn it and then it freed up and i could turn it until the stroke came around again. So i close the lid and went and shoveled the driveway and went inside. There are no holes in the pistions. I guess I got to pull the motor and open it up. I hope i didn't break it to bad.... any ideas easy fix?? is this something comman?? any idea? help !!!


if the bolts line up any 340 should work right???
 
1 - 1 of 1 Posts
Top