Snowmobile World banner

1 - 5 of 5 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
Thanks to you guys I decided to tackle the track replacement on my kids sled.

It wasn't as bad as I thought, the only thing that was bound up was the set screw in the Wheel on the drive spindle. Everything went smooth.

Anyway, here's my plan: replace the .520" track with a .750" and add 96 .875" studs.

I've got a rear heat exchanger protector.

My question is, will these studs clear the front exchanger. :doh:

Anybody been there, done that?

Thanks

Tom
 

·
Registered
Joined
·
50 Posts
Discussion Starter #3
The sled is essentially stock.

The only changes are jets and needles settings.

Under ideal conditions, Temps in the teens and smooth hardpack, I can run to just over 90 mph.
 

·
Registered
Joined
·
678 Posts
They'll clear, I used to have a 1.25 track on mine without any modification.
 
1 - 5 of 5 Posts
Top