Snowmobile World banner
1 - 1 of 4 Posts

· Registered
2,472 Posts
It's normal, the shaft should be cleaned and lightly greased
when you grease the zerk fitting on the jackshaft bearing. The pulley has to be removed to get to this zerk, I usually clean it when I do that. Thinking end play is to allow for self alignment. Honestly I have never had a problem of any kind with alignment. Belt life has been very good on every Polaris I've owned.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.