Snowmobile World banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I finally got my fixed machine back and took it for a spin. Runs great but when it idles then it creeps forward.

Has a new belt
Belt sits about 1/8" down in the driven clutch and seems to grab on the bottom faces of the drive clutch when I move it by hand.

Also the driven clutch can move about 1/4" back and forth on the drive axle shaft, The bolt is tight but seems to have washers that allow the play on the shaft. Is this OK?

Thanks for any help,
Nenty
 

·
Registered
Joined
·
644 Posts
Yep, wrong belt, perhaps wrong clutch (secondary) set-up (too many washers) or even engine improperly mounted.

The play on the shaft needs to be there though 1/4" sounds a bit much.
 
1 - 3 of 3 Posts
Top