[ZR711]

What is the secret of installing a seat cover? Do you sprinkle powder on the foam rubber so you can slide the cover around and get it good and tight?
Thanks in advance.

 

[Darryn Duncan]

Lay the new cover on the top side of the foam cushion then snug it uptight and staple it to the underside. I'm not 100% sure if it works better starting from one point and going around the seat or alternating side as you move down the seat.

 

[newf]

I just finished installing one last month.

You need 1/4 inch staples.  Any longer and you may pierce through the seat cover.  I put a staple every inch.

I started with the front, then sides, and last the back.  I had to use the wifes hair dryer to get the wringles out.

newf