Snowmobile World banner

1 - 5 of 5 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
I was wondering if anyone has put their own c&a skis on wondering how the washer go.I think i have it right but seems to be alot of slop I take it that the 2 big washers go on the outside and the ones with the sleaves go inward sleave part in to the ski . Our do ijust keep tighting to the slop is gonr or should i get some washers as spacers.thanks.
 

·
Registered
Joined
·
310 Posts
Put the gold colored washer on the INSIDE of the ski, and yes they are a pain in the nuts to get in the hole. you might have to use pliers to get them in there. the silver big washers go on the OUTSIDE of the ski, and then the bolt goes through.
 

·
Registered
Joined
·
42 Posts
Discussion Starter #3
Sledcrazzy so did tou take the slopp out by tighting untill it was gone or did you and washers on the inside
 

·
Registered
Joined
·
310 Posts
i just sent you a PM
 

·
Registered
Joined
·
85 Posts
I had a hell of a time with mine also. Would be nice to have some instructions. Mine only came with the thick silver washers which ended up going between the bushings and the ski saddle. Added my own washers under the bolt and nut head. Took a while to figure out the rubber pad also. :(
 
1 - 5 of 5 Posts
Top