[flyntriple]

I'v got a quick queston on carbs on a 97 zrt 600
I have to take the float bowl off and clean the water out of them so do I need to re-sync the carbs afterwards even if i DON'T remove the cables.

 

[arcticman]

you shouldnt ,as long as you dont you bother the float level adjustments or any of the air screws or the caps, assuming there isnt dirt in there that will affect the tuning once removed & clean again.... id clean & drain & run , if theres a problem then some fine tuning may be needed....but probably just mixture  screws if anything...

 

[Darryn Duncan]

You shouldn't have to do anything after cleaning your float bowls, like arcticman said as long as you don't accidently bump anything else.

 

[FishHog]

Nope, just clean and go.  Like these guys said.

FishHog

 

[84EVR]

If you have the glass eyes on the carbs, Then check them to verify. I just did one last night for the first time and it was pretty easy. They actually were out of sync. But if yours are in sync before you do the cleaning, I would agree that they shouldn't go out of sync just from cleaning. Just my two cents. Send me a message if you have any questions.

 

[ZRT600MtnCat]

$65 gets the tool. I check the synch of my carbs frequently. Doesn't hurt to check when you have time but usually they come out the same as last time in your case.