Snowmobile World banner

Ceramic coating the exhaust.

4667 Views 7 Replies 6 Participants Last post by  DrZOOM
I am planning on having my entire exhaust ceramic coated. The Y-pipe, tuned pipe, U-turn and the muffler. All of them on the inside and out exept the muffler wich will be outside only.

Somebody I spoke to today says he didnt have good luck with his and it came off his tuned pipe. According to him its because the factory used cheap high carbon content steel that expands and contracts too much.
Is this just his own bad luck or is it true that it tends to come off the factory pipes?
My ceramic coater says no. Its fine. Just someone elses bad job.
1 - 1 of 8 Posts
Snowmobiles that get trailered and not properly covered get covered in salt and road grime build up on the engine and pipe, heck even properly covered sleds in sloppy condions get wet and salt covered.  If this is the case they must be cleaned soon after or the aluminum gets pitted/white and the pipes turn to a rusty mess.

A ceramic coating will heat the pipe faster plus stop up to 50% of radiant heat coming from the pipe.  If you get the ceramchrome type from Performance Coatings they will not only ceramic coat the outside but also the inside to stop rusting and smooth flow.  This coating does not chip or peel (am not sure on the SwainTech white ceramic coating but the cermachrome does not).  I would highly recommend getting both the pipe and y-pipe done.  I have mine ceramachromed and the y-pipe black satin ceramic coated.  

Check mine out at:  http://mxz670.tripod.com/99670HOTH.html
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top