Snowmobile World banner

1 - 3 of 3 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter #1
Just wondering what the spec is for torque on the primary clutch bolt. Do I just crank it on as tight as I can?

Thanks!
 

·
Registered
Joined
·
3,365 Posts
Sorry, not sure of an exact spec to torque it to.

I just go till it's "snug".  Not as hard as I can tighten it, but tight enough to know it won't come out, if that makes any sense.....haha
 
7

·
Guest
Joined
·
0 Posts
Torque for most A.C. clutch bolts is 50-55 ft. lbs. I first torque it to 50 ft. lbs then run the sled up and down the road a few miles then re-torque to 55 ft. lbs.
If you have tightened the bolt as tight as you can I would buy a new bolt and try it again. Chances are you have stretched the threads on the bolt.  
 
 
 
 
1 - 3 of 3 Posts
Top