Snowmobile World banner

1 - 7 of 7 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
hey, my sled was acting up latly and couldent figure out was was roung, makin noises and stuff, so i was lookin around and notices my clutch yah could move it up and down a lil bit,would the berrings be gone in it or wut would the probley be, it dosnt seem to of lose any power, and the motor and shaking really bad and a load noise come in from it,

Thanks
 

·
Registered
Joined
·
335 Posts
i would agree...if the clutch was going it would be stalling and burning up belts...crank shaft.
 

·
Premium Member
Joined
·
269 Posts
The whole engine has to be removed, and torn apart, the bearing will need to be pulled off, and pressed on.

If its not a end bearing, the crank need to be 'split' to be replaced. Its pretty precious work.

you shouldnt really be using it like that, it could fuc* things up pretty bad if it tears apart or locks up completely. get it checked...

-steve
 

·
Registered
Joined
·
2,032 Posts
you should be able to handle all but the bearing press. under $100 if you drop off the crank to the repair shop as opposed to the whole motor.
 
1 - 7 of 7 Posts
Top