Snowmobile World banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,024 Posts
Discussion Starter #1
I need to get my crank from the ZRT rebuilt (800). It is out of phase (# 1 is 1/2 degree out). I am not sure about the bearings, but assuming the worse, what am I looking at for a good rebuild with having it retrued/phased/welded, new bearings and seals? Any suggestions who to do it? Does anybody here do it?

Thanks
 

·
Registered
Joined
·
980 Posts
It may be less costly to get a new one exchange. Contact your dealer for a cost on the factory crank exchange program. You should also contact local and reputable machine shops to find out what you're up against. It has to come apart to replace the bearings and to put it back in phase. You'll also want to look into getting the balance shaft rebuilt too.
 

·
Registered
Joined
·
14 Posts
I need to get my crank from the ZRT rebuilt (800). It is out of phase (# 1 is 1/2 degree out). I am not sure about the bearings, but assuming the worse, what am I looking at for a good rebuild with having it retrued/phased/welded, new bearings and seals? Any suggestions who to do it? Does anybody here do it?

Thanks[/b]

give jobi davids a call on this one 920 787 3868

he can have it taken care of then weld it for you and re true it
 
1 - 6 of 6 Posts
Top