Snowmobile World banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Ok, I've got way too much float on the shaft of my driven clutch. Service manual says 1.5mm is OK but I've definitly got more than that. So if I need to move the clutch out I add a washer behind the clutch, no problem. Now if the clutch has to go in where do I put the washer? Obviously outside the clutch but where in the sequence of the 3 existing washers? Do I need to buy a clutch alignment tool or can I rig something up, anyone got the dimentions for one?

Thanks!
 

·
Registered
Joined
·
3,008 Posts
A standard bar type alignment tool is fairly cheap and will last for years. A little extra movement never seems to bother them but it wouldn't hurt to get it right.
Rick.
 
1 - 2 of 2 Posts
Top