Snowmobile World banner

1 - 7 of 7 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
I had my suspension rebuilt and i was reinstalling my skid frame, I got the front bolted in, but the rear bolts and holes are misalgined by about 1/2 inch. Anyone got any tips for getting that thing back in there? Thanks for the help
 

·
Senior Member
Joined
·
10,054 Posts
I have a buddy sit on the sled and I use a bat to compress the suspension,,,, I would bet that I ratchet strap as Mark suggested would work better than my old softball bat,,, but someone helping sit on it to compress it has always helped.
 

·
Registered
Joined
·
1,297 Posts
if doing alone. i unbolt rear springs and align bolt holes up. use a large srew driver or bar to hold spring as you take bolts out. becareful there is some good tension on spring. after installing rear bolts. reverse step to install springs.
 

·
Registered
Joined
·
1,558 Posts
hey man like to see a pic of this when its all gone, your going to love the hole suspension now with the rebuilt shocks, it will ride 10 time better.
 
1 - 7 of 7 Posts
Top