Float Arm

738 Views 2 Replies 2 Participants Last post by someone11, Feb 23, 2007

Discussion Starter · Feb 23, 2007

I this how high the float arm is supposed to sit?

1 - 3 of 3 Posts

Nope, it should be almost parallel to the bowl gasket surface.... about 18mm bend the small tang that contacts the needle valve to adjust.

Discussion Starter · #3 · Feb 23, 2007

ok, i thought it was a little peculiar

thanks

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.