Snowmobile World banner

1 - 7 of 7 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter #1
Yamaha replaced inside clutch face when a motor mount failed and caused clutch to make contact w/frame.Are these sheaves balanced independently?Also can the engine bearings handle a little aluminum [filings]?
 
A

·
Guest
Joined
·
0 Posts
What do you mean, filings? How would the filings get to the engine bearings?
 

·
Registered
Joined
·
109 Posts
Discussion Starter #3
The clutch got chewed up and aluminum shavings,dust,particles,whatever were in the foam and under it, stuck to oil and gas in breather box,and in belly pan.Dealer says anything that went in engine probably went out the exhaust?
 

·
Registered
Joined
·
678 Posts
Nothing personal, but your dealer's a jacka$$, metal shavings in the cylynders could cause severe damage! If this was repaired under warantee, I would make sure he disassembled, inspected and cleaned everything. Is he willing to assume all the reponsibility if your motor gets ruined!
 
A

·
Guest
Joined
·
0 Posts
:withstupid: Make 'em tear it down. Good way to check the condition of your motor.
 

·
Registered
Joined
·
1,026 Posts
clutches are balanced as a unit thats why you mark them when you take them apart hope that helps ;)
 
1 - 7 of 7 Posts
Top