Snowmobile World banner

1 - 6 of 6 Posts

·
Registered
Joined
·
310 Posts
Discussion Starter #1
if i buy a dynoport single pipe and silencer for my mxz 600, how difficult is it to jet?  ive never jetted anything before.  can i have my dealer do it for me or what??
 

·
Registered
Joined
·
660 Posts
Call dynoport tech support,

1-315-252-2113

They will give you a jetting baseline. Use the baseline with a jet conversion chart to fine tune to your altitude and temperature.
 

·
Registered
Joined
·
2,422 Posts
What about clutching? Once you start messing around with the engine there are a lot of factors to consider. This is a good place to get info and learn. You just need to make up your mind if it's worth the hassle [sometimes] enjoyment [other times] either way it's how you learn about your sled and is a lot of fun! GOOD LUCK!
 

·
Registered
Joined
·
0 Posts
I'm not really sure that you would want your dealer to do
any of the mods or required jetting changes as it would most
likely void your warrenty. hehehe

I'm sure most of us can help steer you in the right
direction. Just remember when changing jets, start big
(rich) then work your way down. And like Mikadoo said, to
get the most out of your money that you spend on the pipe
you'll have to reclutch some.
 

·
Registered
Joined
·
692 Posts
dyno sells the clutchs for there pipes, with no shopping around id stick with a dyno set up. bickford has good set ups for 600s not sure about the twins?
 
1 - 6 of 6 Posts
Top