Snowmobile World banner

1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
Assume I have taken my Oil pump out of my sled, and now would like to reinstall it, and make sure it is working properly.

I have just done a top end and I am now running premix gas until I can be sure the injection system is working.

I know I need to Bleed the system I am looking for a simple procedure to do this.

Thanks
 

·
Registered
Joined
·
2,422 Posts
There's a small hex head screw on the pump just above the arm the cable is hooked to. loosen this screw, oil and air will run out but leave it open until all air is out of the big line comming from the tank to the pump.
The small lines going to the motor will be ok as the pump will push the air out into the motor. Lay a rag under the pump.
 

·
Registered
Joined
·
21 Posts
Discussion Starter #3
Thanks for the help I will look tomorrow night
 
1 - 3 of 3 Posts
Top