Parting Out A 2002 Ski Doo Mxz 800

I am parting out a 2002 Ski Doo MXZ 800 w, RER.

Parts sold:

Cudney Piston and Rings:
Jugs
Needle Bearings
Pins'
Recoil
Primary
Secondary
RER Pick ups
Four Smaller idler wheels w/ mounts
RH Trailing Arm
Bulkhead and tunnel
Y-Pipe
Pipe
Stock Can
OEM Reeds and Boots
Hood

I have to sell:

A brand new 800 crank with updates. Never used or installed.
OEM pistons and rings
Dynoport Can
Crank Case
Rebuilt stator with only 300 miles since rebuild
Rear Skid w/o shocks or Idler wheels
Seat
Belly Pan
Rear Shocks-Just rebuilt 200 miles ago
Rip Saw Track 15X121X1.25 inch clipped every third-only 200 mile on it.
Coolers

Many items on Ebay Here is a couple of links I have about 15 auctions going check them out from these links or under seller name coaff299:

http://cgi.ebay.com/ebaymotors/ws/eBayISAP...8019&rd=1,1
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...3266&rd=1,1[/b]

Click to expand...

I am parting out a 2002 Ski Doo MXZ 800 w, RER.

Parts sold:

Cudney Piston and Rings:
Jugs
Needle Bearings
Pins'
Recoil
Primary
Secondary
RER Pick ups
Four Smaller idler wheels w/ mounts
RH Trailing Arm
Bulkhead and tunnel
Y-Pipe
Pipe
Stock Can
OEM Reeds and Boots
Hood
Crank Case

I have to sell:

-A brand new 800 crank with updates. Never used or installed.
-OEM pistons and rings
-Yellow Belly Pan ( I will ship this charging actual shipping charges from UPS using oversized 3 chart or I will make a box and pack it and drop it off anywhere that you arrange with in 20 miles from my house)
-SC 10 III skid minus the shocks and springs
-Heavier Fat Man Springs (selling seperate from the skid)
-Coolers
-Steering Parts (Handle Bars, Steering Stem, Radius Arms, Steering rods Ect.)
-Gas Tank
-Temp Gauge w/ Sending Unit
-Fuel Gauge w/Sending Unit
-Tach Gauge
-Speedo Gauge
-Headlight
-Body Parts
-Fett Bros Boot Grips
-Left & Right Hand Boot Stirrups
-Left & Right Hand Trailing Arm mounts
-Fuel Pump
-Jack Shaft
-Brake rotor
-Two Brake Calipers
-Mater Cylinder

Items on Ebay
Dynoport Can
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...p;rd=1&rd=1
Rebuilt stator with only 300 miles since rebuild
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...p;rd=1&rd=1
Seat
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...p;rd=1&rd=1
Rear Shocks-Just rebuilt 200 miles ago
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...p;rd=1&rd=1
Rip Saw Track 15X121X1.25 inch clipped every third-only 200 mile on it.
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...p;rd=1&rd=1

I have 30 Ebay auctions total, if you are looking for something check them out.[/b]

Click to expand...

Looking for both radius rods for right side and the right side plastic vent piece that the pull rope and choke cable goes through. How much shipped to 48430?[/b]

Click to expand...