Snowmobile World banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
has anyone had a problem with the cable that goes into the power valve if they are loose? should they be loose or tight? i have one of both and i have never noticed before, so will it be a problem if they are loose, since i figure it shouldnt be like that, but i could be wrong. should i just put a small washer under the plate that holds it down or ?
 

·
Registered
Joined
·
28 Posts
has anyone had a problem with the cable that goes into the power valve if they are loose? should they be loose or tight? i have one of both and i have never noticed before, so will it be a problem if they are loose, since i figure it shouldnt be like that, but i could be wrong. should i just put a small washer under the plate that holds it down or ?[/b]

there should be an adjustment thread some where on your cables
 
1 - 2 of 2 Posts
Top