Snowmobile World banner
1 - 4 of 4 Posts

· Registered
Joined
·
236 Posts
Discussion Starter · #1 ·
Has anyone put a RK Teck head on a mxz 600. How did it work,I am told from R.K teck that if one of these heads is put on a 600 it will run with a stock 700. Does any one know if this is the case. Thanks for any info.

 Muskoka.doo
 

· Registered
Joined
·
236 Posts
Discussion Starter · #3 ·
Well anyone have any info  
 

· Registered
Joined
·
68 Posts
I have one on my wife's 600 DLX. I have only had two chances to ride with this beautiful winter. The sled is totally stock except the head. No chance to tune it yet but last year I had twins porting etc on my 2000 700 and I believe the 600 would beat it in a drag race. No where here to run top end. I still need to jet down and clutch the sled. It over-revs to 8100 out of the hole then slides back to 7800 as you go. I have a 53/47 helix to install but all there is to ride on is dirt. I'll be dropping two jet sizes along with the helix. We were leaving for St. Michel-des-Saints a week from today but it doesn't look good. Already postponed the trip from mid Jan. My 700 is vastly improved over last year so no chance to compair them now. My dealer rode it after GLH got done with the clutching and said it was the fastest sled he'd ever been on. I'll be able to give a good report if we ever get to go on to Quebec. We'll be riding with a Sppedwerx preped MXZ 800 and a highly tuned 2000 form Z 700. Begging, praying and pleading for snow!!!!!!!
ronzx9
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top